Voltage to get good, appropriate and safe use of electrical equipment, you note:
Select the machine: to select the correct voltage range to work with appropriate and adequate capacity.
Voltage: Normally just select a machine with a voltage range from 150V to 250V work is complete. In areas where electricity is too low, they must choose a wide range.
Power: For the full nominal wattage of the device. As the weaker power in the lower engine power.Therefore need to reduce the load to suit (See capacity chart.)
Installation:
Preparation: Choose good conductors and large enough (eg wire ɸ = 2.5 mm, the machine 3000VA). If the wire is too small for the required pressure drop on the line will be larger, reducing engine power. If the user downloads a large knife for each download.
Installation:
Put in place a cool, dry, easy to observe.
INPUT (vào) Electrical Input: Connect the INPUT deposit once on (on)
Electrical Output: OUTPUT Retrieved from pile (out) or from the socket.
To address: grounding wire should be connected to chassis ground.
Power plays in the machine, idle load stable from 5 ÷ 10 seconds, then turn on each load.
Note when using:
Does not use overload.
When unexpected power loss, to cut off the machine load voltage. Khi nào có điện sẽ lần lượt bật lại. When power will turn on again.
Does not let water fall on the machine.
Does not move when the machine is power.
.jpg)
